Phone scanning gets taught as if everyone has a sunny desk and unlimited time. In practice you’re scanning a lease in a parked car, a discharge form in a hospital corridor or a signed contract on a hotel bedspread at 11 p.m. The good news is that three things decide almost every scan: the light, the angle and what’s behind the page. Get those right and the app does the rest. Get them wrong and no amount of editing will save you.
Light: even beats bright
The instinct is to find the brightest spot. What you actually want is the most even spot. A page that’s brilliantly lit on one half and in shade on the other is far worse than a page that’s uniformly a little dim, because the clean-up step that turns paper white can only do so much when one half is far darker than the other. The dim side may stay gray, while the bright side can wash out faint text.
Some rules of thumb that hold up:
- Daylight from a window, from the side, is ideal. Put the page near the window, not in the direct sunbeam. Direct sun creates hard shadows from every curl in the paper.
- A single ceiling light directly overhead is the classic trap. Your head and phone sit between the light and the page, and you cast a shadow right over the text. Shift so the light is in front of you, past the top edge of the page.
- Two light sources beat one. A ceiling light plus a desk lamp, or a window plus a lamp, fill in each other’s shadows.
- Skip the flash in most cases. Phone flashes make a hot spot in the center and a dim ring around it, and they bounce off glossy paper. If it’s genuinely too dark to scan without one, hold the phone a bit farther away so the light spreads, then crop.
Color temperature matters less than you’d think. A warm yellow lamp is fine as long as it’s even.
Angle: get above it
The second variable is where the phone sits relative to the page. Perspective correction is clever, but it works by stretching the far part of the image to make a trapezoid into a rectangle. Stretching means the far edge has fewer real pixels behind it than the near edge, so text there looks softer. The fix is simply to hold the phone directly over the page, lens pointing straight down, screen parallel to the paper.
If you can’t get directly above (the page is on a high counter, say), move the page rather than contorting yourself. A clipboard on your lap often works better than a table.
Watch for two other angle problems. First, holding the phone too close forces the camera to focus at its minimum distance, and some phones switch lenses or struggle to focus there. Back off until the page fills most of the frame with a small border around it. Second, tilting the phone sideways while capturing produces a smear. Hold it with both hands, or rest your elbows, and wait a moment after tapping before you expect a sharp result.
Background: put light paper on a dark surface
Scanning apps find the page by looking for a strong edge between paper and whatever’s underneath. A white sheet on a white desk gives the app almost nothing to work with, and you’ll get crops that cut off a margin or include half the desk. A dark, plain, matte surface makes the edge obvious.
Good backgrounds: a wooden table, a dark countertop, a dark folder or binder, a car seat, a pair of jeans if you’re desperate, a dark book cover. Poor backgrounds: patterned tablecloths, glossy surfaces that reflect the ceiling, white bedsheets, a pile of other papers.
Scanning one page on top of the rest of the stack confuses edge detection, and text from the page underneath can show through thin paper. Scan each page on its own.
Scanning in awkward places
In a car
Parked, engine off, sunshade down. A car interior during the day has decent, diffuse light, but the windshield creates glare and the dashboard creates hard shadows. The passenger seat is usually your best surface: dark, matte and flat enough. Turn so the brightest window is in front of you rather than behind. At night, the dome light alone is usually too weak and too directly overhead; a phone flashlight from a second phone, held off to the side, is better than the scanning phone’s own flash.
In a hotel room
Hotel lighting is famously dim and yellow, and desks are often glossy. Turn on every light in the room. Use the bedside lamp pulled to the desk as a side light. If the desk is shiny, put the page on the dark folder the room information came in, or on a closed laptop.
In a waiting room or hallway
Fluorescent ceiling panels are bright but directly overhead. Stand with the page on a clipboard or a magazine, and tilt your body so you aren’t between the light and the page. Fluorescent light can sometimes cause faint banding on screen; if you see stripes, move a little and try again.
In the kitchen
Kitchen tables under a pendant light are shadow factories, and the surface is often the wrong color. A pale tablecloth or a white counter swallows the page edges, so lay a dark dish towel, a cutting board or a closed laptop underneath. Move the page off center so the light falls across it at an angle, or bring a desk lamp in from the side. Clear everything else off the surface first: a coffee mug at the edge of the frame can confuse edge detection as much as a patterned cloth.
At night, the under-cabinet lights over a counter are surprisingly good, since they come from the side and are even. Turn on the overhead light as well so the room isn’t dim behind the page.
Outdoors and on a porch
Open shade is the best outdoor light. A page in full sun gets hard, high-contrast shadows from every crease and from your own arm, and the screen is hard to see. Stand so the sun is to one side, put the page on a dark clipboard, and shade it with your body only if the shadow falls clear of the paper. Wind is the real enemy: pin the page under the clipboard clip or a dark book, and scan each page quickly.
On a counter at a pharmacy or a bank
Counters are glossy and the light is usually overhead. Ask for a dark folder or lay your jacket flat, and keep the page near the edge of the counter so the light reaches it without your head getting in the way. People are waiting behind you, so settle the setup before you take out the paper. If the page is sensitive, angle it and your screen away from people nearby.
When the paper is the problem
Some documents fight you no matter where you are.
Curled or folded pages cast tiny shadows along every bend and make lines of text wavy. Flatten them under a heavy book for a few minutes. If you need to hold a corner down, use something dark so it doesn’t confuse the edge detection, and crop it out afterwards.
Glossy paper, such as some letters from banks or photo printouts, reflects the light source straight into the camera. Tilt the page slightly away from the light until the glare spot slides off the text. A very small angle is enough, and perspective correction handles the rest.
Thin paper with printing on the back can show through. Put a sheet of dark paper behind it, or scan on a dark surface rather than a light one.
Carbonless copies and thermal receipts often have faint, low-contrast text. These need more care; our guide to faxing receipts and photos goes into them.
Let the app do its part, then check it
A good scanning app automates what’s left once you’ve set up the shot. FaxLane, for instance, detects the page edges, captures the page automatically, and offers crop and clean-up so the paper comes out white. What no app can do is invent detail that the camera never captured, which is why the setup above matters.
If a page fails, rescan it then and there, while you’re still in position. It takes ten seconds, and much longer once you’ve moved on and the office has called to say page four is unreadable. What a finished page should look like before it goes out is covered in the anatomy of a readable fax.
A quick setup checklist
Before you start a batch, run through this:
- Light is even across the page, coming from the front or side, not behind you.
- Phone is directly above, lens pointing straight down, with a small border visible.
- Background is dark, plain and matte.
- Page is flat, unstapled, and on its own.
- You’re holding still and letting focus settle.
That’s it. None of it requires special equipment, and once it becomes habit, a clean scan takes about as long as a bad one. If you’re scanning specifically for fax, the next step is understanding what the fax conversion will do to your page; our guide to scanning for fax covers the review step and what to fix before you send.
Quick answers
What is the best background for scanning a document with a phone?
A plain, dark, non-shiny surface works best, such as a wooden table, a dark folder or a car seat. The contrast between the dark surface and the white page lets scanning apps find the edges accurately. Avoid white tables, patterned tablecloths and glossy surfaces that reflect light.
Should I use the flash when scanning documents with my phone?
Usually not. A phone flash tends to create a bright hotspot in the middle of the page and can wash out text, especially on glossy paper. Even, indirect light such as a window or a bright room is better. If you have no other choice, try scanning from slightly farther away so the flash spreads more evenly.