Faxing receipts and photos without losing the faint print

How to fax thermal receipts, faded copies and photos so the amounts, dates and details stay readable after the page is converted to black and white.

Reimbursement claims, expense reports, warranty requests and insurance claims all have something in common: someone wants to see the receipt, and sometimes a photo. Fax is unkind to both. Receipts are small, faint and printed on paper designed to fade. Photos are full of gray shades that fax has to fake with dots. Sent carelessly, the receipt arrives as a blank strip and the photo arrives as a dark rectangle.

With a bit of care, both can come through readable. Here’s how, starting with the harder of the two.

Why receipts are so difficult

Most till receipts are thermal prints: the paper darkens where it’s heated, no ink involved. The text is often a light gray rather than black, it fades with time, heat and sunlight, and the paper curls. Many receipts are also long and narrow, which means that when they’re fit onto a letter-size page, they either get shrunk or leave a lot of blank space.

Fax usually sends pure black and white (the guide to resolution and file size explains why). Light gray text is right on the edge of that conversion. Some letters survive, some don’t, and you get “TO AL 4 .9” instead of “TOTAL 42.95.”

To fax a receipt well, make the text as dark as you can against the paper before it’s converted, and keep the text as large as you can on the page.

Scanning a receipt, step by step

  1. Flatten it. Press it under a heavy book for a few minutes. A curled receipt creates shadows that look like text to the conversion and hide the text that’s actually there.
  2. Put it on a dark, matte background so the app can find the edges of a narrow strip.
  3. Use soft, even light and skip the flash, which flares on thermal paper. The guide to clean phone scans covers light and surfaces.
  4. Get close enough. The receipt should fill most of the frame. For a long one, scan it in two overlapping parts rather than shrinking it to fit, and label them “top” and “bottom” in your cover note.
  5. Crop tightly. Keep the whole receipt, including the store name at the top and the date and total at the bottom, but no extra table.
  6. Use a document or black-and-white filter, then check. Zoom in on the total, the date and the merchant name. These are the three things the recipient most needs. If any are broken up, try a grayscale filter with higher contrast, or raise the contrast in your phone’s photo editor, and compare.

When the receipt is already faded

If a receipt has faded to the point where you can barely read it in hand, no scan will make the fax crisp. A few options:

  • Try a few lighting angles. Faint thermal print sometimes shows better with light coming in low from one side.
  • Check if there’s a digital copy. Many stores email receipts or show them in an account. A digital receipt saved as a PDF will fax far better than a photo of a faded slip.
  • Include supporting proof. A card or bank statement line showing the same date, merchant and amount can back up a hard-to-read receipt. Check whether the recipient accepts this. If they do, cover unrelated transactions on the paper before scanning and check the preview.
  • Add a typed note. On a separate page or the cover, list “Receipt 1: Harbor Hardware, May 6, $42.95.” It doesn’t replace the receipt, but it helps the reader interpret what they can see.

Don’t trace over faded numbers with a pen. That can make a receipt look altered, which is the opposite of what you want on a claim.

Fitting several receipts onto pages

If you have a handful of small receipts, you can either send each on its own page or arrange several on one page. Each approach has a trade-off.

One receipt per page keeps each one as large as possible and makes it easy for the recipient to match each receipt to a line on your claim form. It does make the fax longer.

Several per page, done by laying them out on a dark surface and scanning them together, keeps the packet short but shrinks each receipt. That’s fine for receipts with large, dark print. It’s risky for faded ones.

A reasonable rule: if you can comfortably read every number on the combined scan at normal zoom, combine them. If you need to pinch-zoom, give each its own page.

Whichever you choose, put the receipts in the same order as the items on your claim or expense form, and number them if the form references them.

Faxing photos

Photos come up for damage claims, warranty returns, rental move-out disputes and proof of an item’s condition. The challenge is different from receipts: rather than faint text, it’s a picture full of in-between tones that the fax has to reduce to black and white.

Decide what the photo needs to show

A photo of a whole room to show a stain on the carpet is a gray blur after faxing. A close crop of the stain, with something for scale, might actually show something. Before you send, ask what one detail the recipient needs to see, and crop to make that detail big.

Adjust before you send

Faxed photos often come out darker than expected. Brighten the photo a little, raise the contrast, and if there’s a key edge (a crack, a dent, a serial number), make sure it stands out against what’s around it. Your phone’s photo editor can do this in a few seconds.

Preview in black and white

Convert a copy to black and white, or apply a document filter, and look at it. If the detail is visible in that preview, it’ll likely be visible on the fax. If it’s lost, adjust brightness and contrast again, or crop tighter.

Add a caption

Under or beside each photo, or on the cover page, write what it shows: “Photo 2: crack in rear bumper, left side, taken June 4.” On a grainy fax, a caption turns a puzzling image into evidence.

Mention if the originals exist in color

Some recipients, such as insurers or landlords, may accept or prefer color originals by another route. A line on the cover like “Color photos available on request” can save a round trip. Follow their instructions on how to send them.

ID cards and other small cards

Driver’s licenses, insurance cards and student IDs combine the problems of both: they are small, they carry tiny print, and they usually have a photo and a glossy or laminated surface.

  • Scan both sides, each on its own page, with the front first. Offices often need the back, and forgetting it means another request.
  • Kill the glare. Laminate and plastic reflect light straight into the lens. Tilt the card slightly until the bright spot slides off the numbers.
  • Enlarge it. A card shrunk onto a full page has text too small to read. Crop tightly and scale it up so it fills a good part of the page, then check the card number and expiration date at full zoom.
  • Expect the photo to be rough. The portrait will arrive dark and grainy. The text is what the office usually needs, so make that sharp.
  • Ask before you include more than requested. If the office wants only part of an ID, the guide to redacting a document before faxing covers what to black out and what to leave.

An ID card is the kind of page where a wrong number costs the most, so confirm the fax number with the recipient before you send it.

Assembling the packet

Most receipt and photo faxes go with a form: a claim, a reimbursement request, an expense report. Put the form first, then receipts or photos in the order the form refers to them. If you scan with an app like FaxLane, you can combine the form, receipts and photos into one fax and reorder or rotate pages before sending. On the cover page, list what’s enclosed with page numbers, so the reader knows “pages 3–5 are receipts for items 1–6.”

Keep your originals. Fax sends a copy; if the receiving office later wants to see the actual receipt, or the claim is questioned, you’ll want it. A simple envelope labeled with the date and where you faxed it is enough.

And keep the delivery confirmation alongside them. It shows the receiving machine accepted your transmission on a given date, which can matter if a claim has a deadline.

Quick answers

Why do receipts come out blank or unreadable when faxed?

Many receipts are printed on thermal paper, with light gray text that fades with heat, light and time. Faint text can disappear when the page is sent. Pressing the receipt flat, scanning in even light, cropping tightly and checking the total and date on screen gives the text the best chance.

Can I fax a color photo?

You can send one, but it will most likely arrive in black and white and with less detail than on your phone. Crop to the part that matters, brighten dark areas and write a caption saying what the photo shows. If the photo needs to be seen in color, ask the recipient whether there's another way to send it as well.

Keep reading